Setting The Clock; Loudness - PERFECTPRO ROCKBOX Bedienungsanleitung

SETTING THE CLOCK

The clock can only be set when the radio is in standby mode. If no buttons are pressed
for 5 seconds, the radio will exit the clock setup and the setting is cancelled.
1. Press and hold the Time Set knob for 12 seconds until the hour digits flash on the
display.
2. Rotate the Time Set knob to set the hour.
Press the Time Set knob to confirm, the minute digits flash.
3.
4. Rotate the Time Set knob to set the minute.
5. Press the Time Set knob to confirm, the day flashes on the display.
6. Rotate the Time Set knob to set the current day.
7. Press the Time Set knob to confirm, the month flashes.
8. Rotate the Time Set knob to set the current month.
9. Press the Time Set knob to confirm, the year will then flash on the display.
10. Rotate the Time Set knob to set the current year.
11. Press the Time Set knob to confirm, "SYNCLOCK ON" flashes.
12. Rotary the Time Set knob to select "SYNCLOCK ON" or "SYNCLOCK OFF".
13. Press the Time Set knob to confirm and finish the clock setting.
RDS time synchronisation
If "SYNCLOCK ON" is selected, the symbol "
Some RDS stations transmit a time signal. If reception is good and you have
selected the "SYNCLOCK ON" option during the time setting, the time will be
automatically updated ("
several minutes. The automatic time setting is always activated when the radio is
switched from standby to FM broadcasting and receives a RDS station.

LOUDNESS

The Loudness function enables to get compensation on lower and higher frequency.
The effect will be more audible when the radio is in a lower volume level (Dynamic
Loudness).
1. Press the Loudness button to enable the loudness, the display shows "Loudness
On".
2. Press the Loudness button again to disable the loudness, the display shows
"Loudness Off".
" flashes on the display). Time synchronisation can take
" will show on the clock display.
GB
16