Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TC-MX 1400-2 E Originalbetriebsanleitung

6. Operation
6.1 ON/OFF switch (Fig. 4/Item 1)
First fi t a suitable mixing tool to the equipment
(see 5.)
Connect the mains plug to a suitable socket.
Switching on:
Press the locking button (3) and the On/Off switch
(1) at the same time.
Switching off :
Release the locking button and the On/Off switch
(1).
6.2 Speed control (Fig. 5/Item 2)
To pre-select the speed turn the knurled screw (2)
on the switch.
Plus direction:
Minus direction:
6.3 Defi ning the speed range (Fig. 6/Item 5)
The gear selector switch (5) enables you to work
within a specifi c speed range.
Switch position, setting 1 (A)
Speed range: high torque, low speed
Switch position, setting 2 (B)
Speed range: low torque, high speed
Note! Change the gear only when the drill is at a
standstill. If you fail to observe this point, the gea-
ring may be damaged.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anl_TC_MX_1400_2_E_SPK9.indb 16 Anl_TC_MX_1400_2_E_SPK9.indb 16
GB
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
Higher speed
tack the plastic parts of the equipment. Ensu-
Lower spee
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com
- 16 -
Tip! For good results we
recommend high-quality ac-
cessories from !
www.kwb.eu
welcome@kwb.eu
09.12.2020 09:54:14 09.12.2020 09:54:14