Starting The Unit; Cleaning, Maintenance And Ordering Spare Parts - EINHELL Bavaria BMR 1300 Bedienungsanleitung

Anleitung_BMR_1300_SPK1:_
GB
5. Mixer assembly (Ill. 2):
Disconnect the plug from the mains before
undertaking any work on the unit!
First scew mixer part (6a) together with mixer part
(6b). Screw the mixer (6) into the mixer holder (5)
afterwards. Use the two spanners to do this. Use one
of the spanners (a) to hold the mixer holder (5) in
place and then use the second spanner (b) to tighten
up the mixer (6). Proceed in the reverse sequence to
undo the mixer.

6. Starting the unit

Ensure that the data listed on the nameplate concurs
with the mains voltage before connecting the unit up.
On / Off switch
Switching on: Press the switch (1)
Continuous running:
Press the locking knob on the
switch (1) (2) to lock it in place
Switching off: Press the switch (1) briefly
Speed control: Use the speed control (3) to
select the speed.
Switching between 1st - 2nd gear (4)
The switch positions enables you to work at high or
low speeds. The gear switch position should only be
changed when the unit is stopped, in order to prevent
the gearing from being damaged.
1st gear
2nd gear
8
28.12.2006 11:29 Uhr Seite 8
7. Working with the paint and mortar
mixer
The mains plug must be disconnected before the
mixing tool is changed.
The unit should be running at low speed before it is
immersed in or removed from the mixture. The speed
should only be increased to maximum after it has
been fully immersed in the mixture, in order to ensure
that motor is as kept as cool as possible. The
machine must be moved around inside the mixing
vessel during the mixing process. Continue the mixing
process until all of the mixing components have been
processed.
Always clean the mixer after you have finished using
it.
8. Cleaning, maintenance and ordering
spare parts
Always disconnect the mains plug before starting
the cleaning work.
Cleaning
G Keep the safety devices, ventilation slots and
Motor housing as free of dirt and dust as possible.
Clean the unit by rubbing it with a clean cloth or
blow it clean using low-pressure compressed air.
G We recommend that you always clean the unit
immediately after using it.
G Clean the unit regularly by rubbing it with a damp
cloth and a little soft soap. Do not use cleaners or
solvents; these will attack the plastic parts in the
unit. You must also ensure that water cannot get
into the inside of the unit.
Carbon brushes
G If excessive sparking occurs you must have the
carbon brushes checked by a qualified
electrician.
Attention! Only a qualified elecrician is allowed to
change the brushes.
Maintenance
G There are no parts fitted inside the unit that
require maintenence.