Adjustments And Settings - Fimer TM 236 DUAL PULSE SYNERGIC Bedienungsanleitung

Once selected the follow screen will appear:
Ready to weld
>
wire speed
soft start
inductance
2s-4s-4bilevel
spot welding
pause
pre gas time
post gas time
burnback
hot start
water pump

ADJUSTMENTS AND SETTINGS:

Button 9 controls the current and the
machine power.
Button 10 adjusts the welding settings on the
screen:
Wire speed: Used to set the speed of the
welding wire.
Soft-start: Used to modify the speed at
which the wire approaches in order to obtain
a soft arc ignition; high values correspond to
low approach speeds.
Inductance: Used to modify the speed of
variation of the welding current to obtain a
harder arc (low values) or softer arc (high
values).
2t-4t-4bilevel: Used to set the operating
mode to 2 times or 4 times.
2t: In 2 time operating mode the machine
welds for the entire time the torch button is
held down.
Downloaded from www.Manualslib.com
150
A
15,0
V
2,8m/'
1,0 m/'
MIG-MAG
0
S.A.M.
0
2t
0,0 s
0,0 s
0,1 s
2,0 s
2,0ms
0
OFF
manuals search engine
4t: In 4 time operating mode pressing the
torch button once starts the weld and pres-
sing it a second time ends the weld.
START
Spot welding: Used to set (if other than 0)
BACK
MEM +
the maximum duration of the weld.
Pause: Used to set (if other than 0) the dura-
OPTIONS
tion of the pause between two successive
spot welds.
Pre gas time: Used to set the time for deli-
very of gas before striking the electric arc.
Post gas time: Used to set the time of
gas delivery after the welding current has
stopped.
Burnback: Used to vary the burnback time
of the wire at the end of the weld.
Hot start: Used to set the ignition current in
order to obtain a soft ignition; generally used
together with the Soft-start parameter.
Water pump: Used to switch on (ON) or
switch off (OFF) the water pump unit if pre-
sent.
4.2 Synergic Short Arc MIG WELDING
Synergic MIG welding allows the user to
easily adjust the weld settings, according to
the different materials that require welding.
During synergic welding, switch 9 of Fig 1
simultaneously adjusts the tension or the
speed of the wire. The other parameters
are automatically adjusted to the set power,
according to the diameter and type of wire
selected. The percentage of the length of
the arc can be varied using the 'welding
tension' setting. Welding quality can be
further improved by adjusting the 'electronic
inductance' and 'deposit' settings.
11