Backlighting Settings; Setting The Frost Protection Temperature; Setting The Maximum Permitted Boost Duration; Setting The Maximum Ambient Temperature For Automatic Boost Shutdown - Cordivari CLAUDIA BLOWER MISTO 500X763 Betriebsanleitung

English

11.2 Backlighting settings

1-Three modes can be set:
= Temporary backlighting: Display backlighting when a button is pressed.
= Non-stop backlighting: Permanent display backlighting.
= Temporary backlighting: Display backlighting when a button is pressed.
mode is the default setting..
Press or to select the desired setting.
2- Press to save and go to the next setting.
To exit user settings, press

11.3 Setting the frost protection temperature

The device is preset to 7°C. The Frost Protection temperature can be
adjusted from 5°C to 11°C, with increments of 0.5°C.
1- Press or to select the desired setting.
2- Press to save and go to the next setting. To exit user settings,
press twice.

11.4 Setting the maximum permitted Boost duration

The maximum Boost duration is preset to 60 minutes. It is possible to
adjust it from 30 to 90 minutes, with 30-minute intervals.
1- The Boost symbol and heating indicator are shown on the display and
the preset duration of 60 minutes fl ashes.
2- Press or to set the desired duration.
twice.
3- To save and automatically move to the next setting, press
To exit user settings, press
11.5 Setting the maximum ambient temperature for automatic
Boost shutdown
When the Boost is activated in Comfort, Eco or Frost Protection mode,
the fan must heat the room up to the temperature limit: the so-called
maximum ambient temperature.
When reached, the Boost automatically stops and restarts to maintain
this temperature until the end of the Boost period. It is preset to 25°C. It
is possible to adjust it from 20°C to 35°C with increments of 1°C.
The Boost symbol and the heating indicator are shown on the display and
the maximum temperature fl ashes.
1- It is possible to set the maximum Boost temperature by pressing
or from 20°C to 35°C with increments of 1°C.
2- To save and automatically move to the next setting, press
user settings, press

11.6 Resetting factory settings

To return to factory settings, proceed in the following order:
1- From the previous setting, press
2- is displayed. Press
- 34 -
twice.
twice.
, the display shows
or to select
Cod. 1910000002086 - nv00
.
. To exit
.
.