Open Window Detection, Energy Saving - Cordivari CLAUDIA BLOWER MISTO 500X763 Betriebsanleitung

Repeat the procedure described in point 3 for each day of the week.
1 1
5- After selecting a program for each day, confi rm your selection by pres-
sing . The days of the week are shown in sequence on the display
with the corresponding programs set (P1, P2, P3, CONF or ECO).
To exit programming mode, press
• Displaying the selected programs
From Auto, Comfort, Eco or Frost Protection mode, press
seconds. Press twice, the display shows the program set for each
day of the week (Comfort, Eco, P1, P2 or P3) in sequence. To exit
program display mode, press
• Manual and temporary exit from a running program
This function allows temporarily changing the set temperature until the
next programmed change or transition to 0:00.
Example:
1- The device is in Auto mode, the program running is Eco 15°C.
2- Press or , it is possible to temporarily change the desired
temperature up to 16°C, for example.
Note: The cursor corresponding to the operating mode, i.e. Eco mode in
the example, fl ashes for the duration of the temporary change.
3 - This change is automatically deleted the next time the program is chan-
ged or at 12 am
• Manual and temporary change of Boost time in Auto mode
When a Boost is automatically launched in Auto mode, it is possible to
temporarily change the time of the current Boost. This time will not be
Cod. 1910000002086 - nv00
.
twice.
3
saved for the next automatic or manual Boost.
Example:
1- The device is in Auto mode, the program running is Comfort 19°C and
the automatic Boost is in operation.
2- Press or
minutes, for example.
for 5
3- This change will be automatically cancelled at the end of the Boost.

10.11 Open window detection, energy saving

• Important information about open window detection
Important: The open window detection is sensitive to temperature chan-
ges. The device will react to the opening of the window according to
diff erent parameters: set temperature, increase and decrease of the tem-
perature in the room, external temperature, position of the device, etc.
If the device is located near an entrance door, the detection may be di-
sturbed by air caused by the door opening. If this causes problems, it is
recommended to disable the automatic open window detection mode.
Nevertheless, it is possible to use manual activation (see below).
- 31 -
, to temporarily change the desired Boost up to 70
3
2
Legend
= preferable position
= other position
English
1