User Settings; Access - Cordivari CLAUDIA BLOWER MISTO 500X763 Betriebsanleitung

• RF tuning between the remote control and the fan
The remote control and the fan are not connected at the factory, so pro-
ceed as follows:
1- From frost protection mode, press
2- The fan is in tuning mode. Perform tuning of the remote control (refer to
its installation and user manual).
3- When the fan and remote control are connected, the symbol
splayed and remains steady. The fan automatically returns to Frost Pro-
tection mode.
• Checking the RF signal strength
It is possible to check the RF transmission between the fan and the re-
mote control at any time.
To display the RF reception level, from Frost Protection mode, press
for 5 seconds. The level appears on the display.

11.User settings

11.1 Access

The User Settings are accessed in 3 steps:
From Auto, Comfort, Eco or Frost Protection mode:
information display
1
Press for 5
seconds
Sequence of settings:
Backlighting → Frost protection temperature → Maximum Boost time →
Maximum ambient temperature
Cod. 1910000002086 - nv00
for 5 seconds.
2
Press twice
1
0 = High level RF transmission, the remote control position is optimal.
9 = Low level RF transmission:
To improve RF transmission performance between the two devices and
ensure that remote management is optimized:
• Make sure RF transmission is not interrupted, move the remote control.
• Move the remote control closer to the fan.
• Deleting RF tuning
It is possible to delete the RF transmission between the fan and the re-
mote control at any time
From Frost Protection mode, press
is di-
The symbol is no longer displayed: the remote control and the fan are
no longer tuned.
information display
1
- 33 -
English
and for 5 seconds.
= user settings
3
Press
briefl y