Advice On How To Use The Remote Controller; Remote Controller Lock; Light Function; Connection/Disconnection Of The Unit - Vaillant climaVAIR VAI 2-025 WN Bedienungsanleitung

7.3

Advice on how to use the Remote Controller

Follow the recommendations below as to how to use the
remote controller:
- When in use, direct the head of the signal transmitter
directly to the indoor unit receiver.
- Keep the distance between the transmitter and the
receiver within 7 m.
- Avoid obstacles between the transmitter and the
receiver.
- If experiencing difficulties with the remote control
communicating with the indoor unit, reduce the
distance between the remote controller and the indoor
unit.
- Do not drop, throw or strike the remote controller.

7.3.1 Remote Controller Lock

In order to lock the buttons and display of the remote
controller device:
• Press the LIGHT / LOCK button for over two seconds.
The rest of the buttons are deactivated.
The lock status indicator appears.
In order to deactivate the lock:
• Press the LIGHT / LOCK button again.
The rest of the buttons are activated.
The lock status indicator disappears.

7.3.2 LIGHT function

Press the LIGHT / LOCK button for less than 2 seconds
to light the display of the Indoor Unit. To switch the
display back off, press the LIGHT / LOCK button for less
than 2 seconds once again.
7.4

Connection/Disconnection of the Unit

In order to connect the unit:
• Press the ON button on the indoor unit or on the
remote controller; the unit will start to operate.
In order to disconnect the unit:
• Press the OFF button on the indoor unit or on the
remote controller; the unit will stop:
Split Type User Manual
Downloaded from www.Manualslib.com manuals search engine
Operating Instructions 7
7.5

Selection of the Operation Mode

7.5.1 Automatic Mode (AUTO)

In automatic mode (AUTO) the air conditioning unit
automatically selects the cooling (COOL) or heating
(HEAT) mode in accordance with the actual ambient
temperature.
Fig. 7.3 Automatic mode selection.
Legend
1 MODE button
2 AUTO mode indicator
3 TEMP / TIME button
In order to activate:
With the unit connected (see section 7.4):
• Press the MODE button.
The different operation modes are displayed.
Fig. 7.4 Operation modes.
• Select the automatic operation mode (AUTO).
• Press the TEMP / TIME buttons to select the
temperature setting.
When pressing the TEMP / TIME buttons, the temperature
configuration will increase or decrease by 1ºC.
EN 9