Getting Started; Fitting The Remote Controller Batteries; Clock Settings - Vaillant climaVAIR VAI 2-025 WN Bedienungsanleitung

6 Getting started

6 Getting started
6.1

Fitting the Remote Controller Batteries

Insert two batteries (2 No. size AA), as described below
(see Figure 6.1).
Fig. 6.1 Fitting the remote controller batteries.
Legend
1 Battery lid
2 Batteries
A Pressure area for opening the lid
B Battery compartment
• Remove the battery lid by pressing gently on zone A
and pushing the lid downwards.
• Insert the batteries in the remote control ensuring
correct positive and negative polarity (Shown on the
battery compartment).
• Put the lid back on.
• Press the ON/OFF button (see Figure 7.1) to check that
the batteries are correctly inserted.
Note!
If nothing appears on the display after pressing
ON/OFF , refit or replace the batteries.
Always replace the two batteries at the same time.
Note!
If the remote controller does not run properly
during operation, please remove the batteries and
reposition a few minutes later.
Remove the batteries in case the air conditioning
is out of use for a long period. If there is anything
still showing on display, just press the reset button.
Remove the batteries in case the air conditioning is
out of use for a long period. If there is anything still
showing on display, just press the reset button.
6
Downloaded from www.Manualslib.com manuals search engine
Warning!
Danger of the enviromental contamination by not
disposing of the batteries properly.
When replacing the remote controller batteries,
dispose of batteries in the correct manner.
Never throw away in the rubbish.
6.2

Clock Settings

Use the remote controller buttons to adjust the unit
clock the first time the unit is started or after replacing
the batteries, see Figure 6.2.
• Press the CLOCK button once.
The CLOCK indicator start to flash on the remote
controller display.
• Press the TEMP / TIME buttons to set the desired time:
When pressing the  /  buttons, the time
configuration will increase or decrease by 1 minute.
If the  /  buttons are kept pressed, the time will
increase or decrease rapidly.
The CLOCK indicator will stop flashing and the clock
will start to operate.
Fig. 6.2 Clock Settings.
Legend
1 CLOCK button
 / 
TEMP/TIME
2 buttons
3 CLOCK indicator
Split Type User Manual