Gram KF II Bedienungsanweisung Seite 30

GB
Congratulations
on your new refri-
gerator/freezer
Please note that these instructions apply
to all KF models and therefore the acces-
sories/equipment described can vary from
model to model.
WARNING
Old refrigerators and freezers are often
fitted with complicated latches that can
only be opened from the outside. If you
have an old unit like this stored away
somewhere, or if you scrap it, remember
to destroy the latch to prevent children
from being exposed to danger by
getting locked inside the unit.
Note! Please also observe the environ-
mental rules on disposal. See section
"Disposal".
Before using your
refrigerator/freezer
Please read the sections on setting up and
building in, starting up and electrical con-
nection before using your refrigerator/
freezer.
On receipt, check to ensure that the fre-
ezer has not become damaged in trans-
port. Transport damage should be repor-
ted to the local supplier before the refrige-
rator/freezer is put to use.
Fold out the final pages with illustrations.
You will then be able to follow text and
pictures at the same time.
30
Downloaded from www.Manualslib.com manuals search engine
Setting up and
building in
For safety and operational reasons, do not
set up the cabinet outdoors, it should be
placed in a dry room.
The cabinet is designed for temperature
class N in accordance with European stan-
dard EN 153.
Never place the refrigerator/freezer close
to sources of heat such as ovens or radiat-
ors, and avoid placing it in direct sunlight.
It is important that the fridge/freezer stands
completely level and that there is good air
circulation over, under and around it.
The dimensions give the actual size of the
opening. (The figures in brackets apply
when KF 345, KFL 315 & KF 355 units are
built in.). Single cabinets require a circula-
tion area of at least 200 cm
units 300 cm 2 .
1A Building in with ventilation grill in a
standard kitchen element with sufficient
ventilation for the compressor.
1B Building into a refrigerator element with
integral ventilation. Air flows in through
the plinth and is led to the rear of the
cabinet.
Location in cold
Rooms
If your new refrigerator/freezer is to stand
in a room where the temperature is likely
to fall below 16°C problems can arise if the
cabinet has only compressor and one
thermostat.
The thermostat may register that the tem-
perature is satisfactory and will therefore
prevent the compressor operating. This
means that the freezer compartment will
2 , combination