Operating; Adjust The Wedge Ram Stroke; Positioning The Log; Adjusting The Log Holder - Zipper Maschinen ZI-HS8TN Betriebsanleitung

16.2

Operating

16.2.1 Adjust the wedge ram stroke

16.2.2 Positioning the log

Place the log vertically and flat on the support table. Make sure that the splitting wedge and
the support table touch the log at right angles at the ends. Never try to split a log at an angle

16.2.3 Adjusting the log holder

16.2.4 Splitting

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
To set the return stroke position of the
cylinder, proceed as follows:
(1) Move the splitting wedge to the desired
position. The upper position of the splitting
wedge should be about 3~5cm above the logs
to be split.
(2) Release a control lever or switch off the
motor.
(3) Loosen the adjusting screw (A). Lift the
adjusting rod (B) until the adjusting rod (B) is
stopped by the spring inside. Tighten the
adjusting screw (A).
(4) Release both control levers or switch on the
motor.
(5) Check the upper position of the splitting
wedge
Adjust the log holders (A) according to the
diameter of the log to obtain the most
comfortable angle of the control lever
Hold the log with clamps.
Press the levers down to start splitting.
Releasing one of the two levers stops the
movement of the splitting wedge.
Release both levers to move the splitting
wedge back to the upper position.
OPERATION
25
ZI-HS8TN