Safety; Safety Instructions; Transport - Zipper Maschinen ZI-HS8TN Betriebsanleitung

13

SAFETY

Only use the machine in a technically perfect condition and in accordance with its intended use,
safety-conscious and aware of the dangers! Have faults which could impair safety rectified
immediately!
The machine is intended exclusively for the following activities:
For splitting logs in the direction of the grain, with dimensions that are within the specified
limits of the machine.
The splitting process of the machine is intended for operation by only one person.
ZIPPER-MASCHINEN
beyond this and for any resulting damage to property or injuries.
Operating conditions:
The machine is intended for use under the following conditions:
Humidity:
Temperature (operation)
Temperature (storage/transport)
Altitude above sea level
Any improper use or disregard of the information and instructions given in this manual will
invalidate all warranty claims and claims for damages against Zipper GmbH.
Unauthorised use:
 Operation of the machine without adequate physical and mental aptitude
 Operating the machine without knowledge of the operating instructions
 Changes in the design of the machine
 Operating the machine under explosive conditions
 Operating the machine outside the specified power range
 Remove the safety markings attached to the machine.
 Modify, circumvent or disable the safety devices of the machine.

13.1 Safety instructions

Warning signs and/or stickers on the machine which are illegible or have been
removed must be replaced immediately!
Local laws and regulations can determine the minimum age of the operator and
restrict the use of this machine!
In order to avoid malfunctions, damage and health impairments, the following measures for
safe working must also be followed without fail:
 Check the machine for completeness and function before commissioning. Only use the
machine if the guards and other protective devices required for the work are in place, in
good working condition and correctly maintained.
 Select a level, vibration-free, non-slip surface as the installation site.
 Ensure that there is sufficient space around the machine!
 Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
 Ensure a clean working environment
 Use only defect-free tools that are free of cracks and other defects (e.g. deformation).
 Keep the area around the machine free from obstacles (e.g. dust, chips, cut-off workpiece
parts, etc.).
 Check the connections of the machine for strength before each use.
 Never leave the running machine unattended. Switch off the machine before leaving the
working area and secure it against unintentional or unauthorised restarting.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
assumes no responsibility or warranty for any other use or use
max. 50 %
+5° C to +40° C
-25^C to +55°C
up to 1.000 m
SAFETY
19
ZI-HS8TN