Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Preparatory Activities; Bleeding The Hydraulic System; Checking The Rotation Direction Of The Motor - Zipper Maschinen ZI-HS8TN Betriebsanleitung

Vorschau ausblenden Andere Handbücher für ZI-HS8TN:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

16

OPERATION

16.1

Preparatory activities

16.1.1 Installation site

Place the log splitter on a flat and solid surface, which can bear the weight of the machine +
load. Fix the log splitter to the ground through the two holes in the frame

16.1.2 Greasing the ram / splitting wedge surface

Apply a thin layer of grease to the surface of the ram of your log splitter before starting work.
This will prolong the life of the tool.

16.1.3 Bleeding the hydraulic system

Never forget to loosen the oil tank cap! Otherwise the air in the system will be
compressed and released again and again, which will destroy the seals of the
hydraulic circuit and make the log splitter unusable.

16.1.4 Checking the rotation direction of the motor

Never run the motor in the wrong rotation direction. This will damage the pump and
void the warranty.

16.1.5 Check two-hand operation

Before using the machine for the first time, make sure that the two-hand control is working
properly by following the steps below:
(1) Lower both control levers, the splitting wedge lowers to 5 cm above the highest table
position.
(2) Release one of the two levers, the splitting wedge should be in
original position
(3) Release both levers, the ram should automatically rise to the highest position.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
N O T I C E
Vent the hydraulic system before starting the log splitter.
To do this, loosen the cover of the hydraulic oil tank by a
few turns until the air can flow in and out gently.
The air flow through the oil tank should be visible during
operation.
To prevent oil from leaking out, the oil tank cover must
be tightly closed before each transport!
N O T I C E
Phase inverter
Check the rotation direction of the motor. If necessary
reverse the polarity of the motor using a screwdriver
(phase inverter inside the plug - see picture on the left).
OPERATION
24
ZI-HS8TN

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis