Geberit ESG 3 Betriebsanleitung Seite 41

EN
Fault
LED displays for
<General
malfunction>
and <Welding
complete>
up
LED displays for
<General
malfunction>
and <Ready for
welding>
LED displays for
<General
malfunction>
<Welding
procedure>
<Ready for
welding>
up
42
Cause
Electrofusion
machine is
overheating or
operating at too
high an ambient
light
temperature
Operating at too
low an ambient
temperature
light up
Fault current while
welding, e.g. as a
result of dampness
,
on electrical
connections
and
light
Actions
Let electrofusion
machine cool down until
the trouble indication
goes out. Do not
disconnect machine
from power supply
system so that the fan
operates
Do not expose the
electrofusion machine
to direct sunlight
Only operate the
electrofusion machine in
the permitted
temperature range (see
chapter <Technical
data>)
Disconnect the mains
plug
Keep electrofusion
machine, all cables as
well as Geberit
electrofusion coupling,
Geberit electrofusion
tape for anchor point or
Geberit electrofusion
coupling with integrated
thermal fuse dry and
clean
B1158-002 © 07-2016
966.473.00.0 (02)