Surface Planing The Pipes Or Fittings - Geberit Universal 356.200.00.1 Betriebsanleitung

EN
The pipe support prisms must be as far as
possible from the tension devices. Branch
fittings and bends must be placed with the
straight section on the pipe support prisms.
3
Clamp the pipes or fittings with the
adjustable eccentric levers.
4
Turn the hand wheel to the right to press
together the parts to be welded, and check
the fixing of the parts to be welded.
5
Tighten with the adjustable eccentric lever if
fixing is not adequate.
26
Surface planing the pipes or
fittings
WARNING
Danger of fatal electric shock
▶ Avoid contact between the mains cable
and the machine modules.
▶ Do not activate electrical devices until
they have been mounted on the welding
machine and clean and dry Geberit PE
or Geberit Silent‑db20 pipes or fittings
have been clamped.
CAUTION
Danger of crushing
▶ Keep hands away from the openly
routed belt.
CAUTION
Danger of cuts from the planer blade
▶ Keep hands away from the rotating
plane disc.
▶ Only switch the electric plane on and off
in the working position and with a
workpiece clamped in place.
1
Connect the mains plug of the electric plane
to the power supply system.
2
Swivel the electric or hand-operated plane
between the parts to be welded.
18014405647374603-1 © 10-2020
996.254.00.0(07)