cecotec Conga 4690 Ultra Bedienungsanleitung Seite 49

ENGLISH
Edge mode
Press the Edge mode button on the remote control for the robot to start cleaning under this
mode. It will automatically start cleaning along all the surface's perimeters and then will
return to the charging base direct and automatically. If the robot has not started cleaning from
the charging base, it will return to the starting point.
Note: Press the power levels button to switch between the 3 modes: Turbo/Normal/Eco.
Back home mode
Press the Back home button on the remote control in order to send the robot to the charging
base. This function can be activated during any other cleaning cycle and the robot will
automatically return to the charging base and stop the cleaning process. The robot will take
the shortest route back to the charging base thanks to its map memorizing and the smart back
home function.
When a cleaning cycle has been completed or the robot's battery is low, thanks to its Total
Surface 2.0 technology, the robot will also return to the charging base to avoid running out of
battery. Once the robot has recharged, it will resume cleaning from the point it has stopped.
Notes:
Remove the Wet & dry tank from the robot before charging it.
Make sure there are no obstacles in the room being cleaned to ensure the robot can get to the
charging base without problems.
Functions
Pause
While the robot is operating, press the time button on the App, the remote control or on the
robot to pause it and press the same button again to resume cleaning.
Standby
The robot will automatically enter standby mode after 5 minutes of no operation.
Press the time button on the App, the remote control or on the robot to start it up again.
Warnings:
After 12 hours of no operation, the robot will turn automatically off.
The robot will not enter standby mode during charging.
Suction power level
Press the power levels button on the remote control to select the desired power level. Choose
between Eco (low power), Medium (medium power) and Turbo (high power).
Schedule
Warning: The robot cannot be scheduled from more than one device at a time. Make sure to
schedule it either from the mobile phone App or from the remote control.
48