Disposal; Troubleshooting; Erros Codes - Zipper Maschinen ZI-RWM84 Betriebsanleitung

shorten its service life, because water (moisture) could get inside the machine when it is
used..
21 STORAGE
Carefully clean the machine before storage, empty the fluid tanks if available and always
dispose of fluids in accordance with national regulations. Pack the cleaned machine and store
in a dry and clean location.
21.1

Disposal

22

TROUBLESHOOTING

Handling the machine with the power supply up can lead to serious injuries or even
death. Always disconnect the machine from the power supply before servicing or
maintenance work and secure it against unintentional or unauthorised reconnection!
22.1

Erros Codes

Certain errors occurring during operation are automatically detected by the device system and
shown on the display by means of an error code - see table below:
Error Code
ZIPPER MASCHINEN GmbH
ZI-RWM84
Observe the national waste disposal regulations. Do not dispose of
the machine, machine components or equipment in residual waste. If
necessary, contact your local authorities for information on the
disposal options available.
If you buy a new machine or an equivalent device from your
specialist dealer, he is obliged in certain countries to dispose of your
old machine properly.
Error /possible cause
Wheel hood opened when start key pressed
When spin is activated, no rotation signal.
Case 1: Motor is not running.
Case 2: Motor is running but the optical
sensor fail to deliver signal
Hood opened during wheel spinning
When spin is activated, rotation speed is too
low.
Case 1: Motor is not working normally.
Case 2: Motor is running normally,
but the optical sensor fail to deliver
speed signal
Balancing measurement out of range.
Case 1: Wheel mounting is far out of
centering.
www.Zipper-Maschinen.at
W A R N I N G
check
Lower down the hood.
Press
Case 1:
A: Check if the wheel was blocked by
B：Check motor wire connection.
C: Check power supply voltage
Case 2:
A: Check if the sensor works.
B: Check if encoder plate is normal
Press
Lower down the hood.
Press
Case 1:
A: Check if the wheel was blocked by
B：Check motor wire connection.
C: Check power supply voltage
Case 2:
A: Check if the sensor works.
B: Check if encoder plate is normal
Press
Case 1:
STORAGE
C
key to reset.
wheel lift;
C
key to reset.
C
key to reset.
wheel lift;
C
key to reset.
Check the centering of the wheel,
remount it correctly.
47