Safety Devices; General Safety Instructions; Electrical Safety - Zipper Maschinen ZI-RWM84 Betriebsanleitung

Work on electrical components or equipment may only be carried out by a qualified
electrician or under the instruction and supervision of a qualified electrician.

15.3 Safety Devices

The machine is equipped with the following safety devices:

15.4 General Safety Instructions

To avoid malfunctions, damage and health hazards when working with the machine, in addition
to the general rules for safe working, the following points must be observed:
 Before commissioning, check the machine for completeness and function.
 Choose a level, vibration-free, non-slip surface for the installation location.
 Ensure sufficient space around the machine!
 Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects!
 Only use perfect tools that are free of cracks and other defects (e.g. deformations).
 Remove setting tools from the machine before switching on.
 Keep the area around the machine free of obstacles (e.g. dust, chips, etc.).
 Check the strength of the machine connections before each use.
 Never leave the running machine unattended. If necessary, stop the machine before
leaving.
 The machine may only be operated, serviced or repaired by persons who are familiar
with it and who have been informed of the dangers arising in the course of this work.
 Ensure that unauthorised persons maintain an appropriate safety distance from the
machine and, in particular, keep children away from the machine..
 Wear suitable protective equipment (eye protection, dust mask, respiratory protection,
ear protection, gloves when handling tools) as well as close-fitting work protective
clothing - never wear loose clothing, ties, jewellery, etc. - danger of being drawn in!
 Work with gloves on rotating parts is not permitted!
 Hide long hair under hair protection.
 Do not remove any sections or other parts of the workpiece from the cutting area while
the machine is running!
 Do not remove splinters and chips by hand! Use a sliding stick for this purpose!
 Always work with care and the necessary caution and never use excessive force.
 Do not overload the machine!
 Do not work on the machine if you are tired, not concentrated or under the influence of
medication, alcohol or drugs!
 Do not use the machine in areas where vapours from paints, solvents or flammable
liquids represent a potential danger (danger of fire or explosion!).
 Always shut down the machine before carrying out any conversion, adjustment,
measuring, cleaning, maintenance or repair work and always disconnect it from the
power supply for maintenance or repair work. Before starting any work on the machine,
wait until all tools or machine parts have come to a complete standstill and secure the
machine against unintentional restarting.

15.5 Electrical Safety

 Make sure that the machine is earthed.
 Only use suitable extension cords.
 A damaged or tangled cable increases the risk of electric shock. Handle the cable with
care. Never use the cable to carry, pull or disconnect the power tool. Keep the cable
away from heat, oil, sharp edges or moving parts.
 Proper plugs and sockets reduce the risk of electric shock.
ZIPPER MASCHINEN GmbH
ZI-RWM84
 movable guard
www.Zipper-Maschinen.at
SAFETY
33