Cleaning, Maintenance, Storge, Disposal; Cleaning; Maintenance; Maintenance Schedule - Zipper Maschinen ZI-RMM94H 230V Betriebsanleitung

16

CLEANING, MAINTENANCE, STORGE, DISPOSAL

Cleaning

Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and coat the bare machine parts with an acid-free lubricating oil.
Subsequently, regular cleaning is a prerequisite for the safe operation of the machine and a long
service life of the machine. Therefore, clean the machine after each use, but at least once a
week.

Maintenance

Handling the machine with the power supply up can lead to serious injuries or even
death. Always disconnect the machine from the power supply before servicing or
maintenance work and secure it against unintentional or unauthorised reconnection!
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
 Before each operation, check that the safety devices are in perfect condition.
 Check the connections for tightness at least once a week.
 Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.
 Vent the machine 3-4 times a year.
16.2.1

Maintenance schedule

The type and degree of machine wear depend on the operating conditions. The following intervals
apply when the machine is used within the specified limits:
Intervall
Before usage
Before usage
Before usage
1 x month
1 x month
1 x month

16.2.1 Checking the lubricating oil level

Prüfen Sie den Schmierölstand im Schmiermittelbehälter. Falls nötig füllen Sie Schmieröl mit
Viskositätsgrad SAE 30 nach.
16.2.2 Antriebsriemenspannung prüfen
Remove the cover from the left side of the tire changer to gain access to the drive belt. To do
this, loosen and remove the four fastening screws of the cover and remove it. If the belt is no
longer sufficiently tensioned, you can tension it by turning an adjusting screw located on the
motor plate.

Storage

Improper storage can damage and destroy important machine parts. Store packed or
unpacked parts only under the intended ambient conditions!
ZIPPER MASCHINEN GmbH
ZI-RMM94H28
Komponente
Turntable
Oil level
Jaws
Screw connection
Moving parts
Drive belt tension
www.Zipper-Maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
N O T E
W A R N I N G
Aktivität
clean
Check and refill
Lubriacte
Check and re-tighten
lubricate
Check and re-adjust
N O T E
28