Calibration; Operation; Switch Machine On/Off - Zipper Maschinen ZI-RWM84 Betriebsanleitung

17.3.1 Calibration

For proper operation, the instrument must be calibrated after installation and connection to the
power supply. In addition, calibration is always advisable if there are doubts about the correctness
of the displayed measurement results - see Fehler! Verweisquelle konnte nicht gefunden
werden..
18

OPERATION

18.1 Switch machine On/Off

ZIPPER MASCHINEN GmbH
ZI-RWM84
3. Assembly hood
 Loosen the screw (7) of the hollow shaft on the
 Then slide the hood rod (8) over the hollow shaft
4. Fully assembled machine.
www.Zipper-Maschinen.at
back of the machine.
and fasten it with the corresponding screw (7).
With the on/off switch (1) on the back of the
machine, the machine can be switched on
and off by
Tilt the switch to position "I" = switch on
Tilt the switch to position "0" = switch off.
OPERATION
36