Automatic Position Search (Spl) - Zipper Maschinen ZI-RWM84 Betriebsanleitung

18.8.1.2. Automatic position search (SPL)

Procedure
 Press
the SPL key
 The wheel stops turning as soon as all LED lights of the inner weight position indication bar
light up.
 The amount of weight to be attached is shown on the inner weight display.
 The correct position for attaching the weight is on the the inner rim (left) plane exactly in
the uppermost position (12 o'clock position).
 Press the SPL key
 The wheel stops turning as soon as all LED lights of the outer weight position indication bar
light up.
 The amount of weight to be attached is shown on the outer weight display.
 The correct position for attaching the weight is on the outer rim (right) plane exactly in the
uppermost position (12 o'clock position).
NOTICE:
Due to deviations of the wheel weight, the automatic position search SPL could determine a
position for attaching the weight very close to the correct 12 o'clock position.
Turn the wheel slightly forward or backward to find the correct position. You will hear a buzzing
sound as soon as the correct position is found.
 Press the C key
Step 7: After applying the weights, set the wheel dimensions as described in paragraph 7.4
"Setting the rim dimensions" and close the cover.
The result is zero when the appropriate weights have been applied in the correct positions on
the rim.
 Press the <T key
NOTICE:
 Positioning errors may occur when attaching the weights. Especially in case of larger unbalance,
a deviation of a few degrees can cause a residual unbalance of 5-10 grams.
19 MAINTENANCE (SERVICE STAFF ONLY)
Handling the machine with the power supply up can lead to serious injuries or even
death. Always disconnect the machine from the power supply before servicing or
maintenance work and secure it against unintentional or unauthorised reconnection!
The machine is low maintenance and only a few parts need to be serviced. Irrespective of this,
faults or defects that could impair the safety of the user must be eliminated immediately!
- Before every operation, check the perfect condition of the safety devices.
- Check the connections for tightness at least once a week.
- Check regularly that the warning and safety labels of the machine are in perfect and legible
condition.
20 CLEANING
The use of solvents, aggressive chemicals or abrasives can lead to damage to
paintwork and other property on the machine!
Free the machine from dust and other deposits after each use. Only use water and, if
necessary, a mild detergent for cleaning! The use of compressed air or high-pressure cleaners
is not recommended. The latter can reduce the operational suitability of the machine or
ZIPPER MASCHINEN GmbH
ZI-RWM84
, the wheel starts to turn slowly.
, the wheel starts to rotatee slowly.
to exit the SPL program.
to check the exact unbalance value.
www.Zipper-Maschinen.at
MAINTENANCE (SERVICE STAFF ONLY)
W A R N I N G
N O T I C E
46