Care And Cleaning - Kenwood Energysense JK450 Serie Handbuch

key
hinged lid
lid release catch
filter
water level graduations
on/off switch
360° powerbase
cord storage
to use your kettle
1 This kettle has been specifically
made from a clear material to allow
you to easily see the amount of
water inside. The specially designed
graduations on the side of the kettle
enable you measure the exact
quantity of water as it goes into the
kettle. These graduations begin at
the one cup level so that you can
boil enough water for just one cup.
Fill the kettle through either the
spout or the lid. To open the lid, pull
back the lid release catch
are filling the kettle at an angle i.e. at
the tap, simply line up the water level
with the sloping graduations on the
side of the kettle (as shown in the
illustration below). The water level
must be between 'MAX' and 'MIN'
(1 cup, 0.2L).
●
Be economical: do not boil more
water than you need.
●
To improve the quality of your drinks
always use fresh water.
●
Empty the kettle after each use.
2 Check the lid is closed.
3 Plug in and switch on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
●
If you experience problems
with your kettle switching on
and off during use or
switching off before boiling,
check that the flat element is
free from scale - see
"descaling".
●
Your kettle is fitted with a filter to
hold back limescale particles.
●
If you find drops of water under your
kettle, don't worry - it is just
condensation.
boil-dry protection
●
If you switch on with too little water,
your kettle will cut out automatically.
Switch off, remove from the
powerbase and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.
. If you

care and cleaning

●
Before cleaning, unplug your kettle
and let it cool down.
the outside and powerbase
●
Wipe with a damp cloth, then dry.
Do not use abrasives - they will
scratch the plastic surfaces.
the inside
●
Even though your kettle comes with
a filter, you still need to clean the
inside (and the filter) regularly.
the filter
1 Open the lid by pulling the lid release
catch back. Then pull the lid back
.
2 Gently lift out the filter
3 either rinse under the tap or use a
soft brush.
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 To re-fit the filter, locate the filter tab
with the cradle support slot
3
.
.