Care And Cleaning - Kenwood ZJG112 Bedienungsanleitungen

before plugging in
Make sure your electricity supply is
l
the same as the one shown on the
underside of your kettle.
WARNING: THIS APPLIANCE
l
MUST BE EARTHED.
This appliance conforms to EC
l
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
before using for the first time
1 Wrap any excess cord around the
bracket g on the underside of the
powerbase.
2 Fill to 'MAX', boil, then pour the
water away. Repeat 3 times.
key
a spout
b flip top lid
c lid release button
d on/off switch with indicator light
e water level guage
f 360° powerbase
g cord wrap
h filter
to use your kettle
1 Press the lid release button c to
open the lid, then fill the kettle. The
water level must be between 'MAX'
and 1 cup (250mls).
If you live in a hard water area we
l
recommend that you use filtered
water in order to maintain the
appearance and efficiency of your
kettle.
Be economical: do not boil more
l
water than you need.
To improve the quality of your drinks
l
always use fresh water.
Empty the kettle after each use.
l
Rinse out with fresh water if the
l
kettle has not been used for more
than 2 days.
2 Close the lid – ensuring it is latched
down correctly.
3 Plug in and switch on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
139598 Iss 2 Type ZJG112 multilingual.indd 4 139598 Iss 2 Type ZJG112 multilingual.indd 4
Note - To interrupt the boiling
ensure that the switch is
in the off position before
removing from the powerbase.
If you experience problems
l
with your kettle switching
on and off during use or
switching off before boiling,
check that the flat element
is free from scale - see
"descaling".
Your kettle is fitted with a filter to
l
hold back limescale particles.
If you find drops of water under
l
your kettle, don't worry - it is just
condensation.
boil-dry protection
If you switch on with too little water,
l
your kettle will cut out automatically.
Switch off, remove from the
powerbase and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.

care and cleaning

Before cleaning, unplug your kettle
l
and let it cool down.
the outside and powerbase
Wipe with a damp cloth, then dry.
l
Do not use abrasives - they will
scratch the glass, metal and plastic
surfaces.
the inside
Wipe with bicarbonate of soda on a
l
damp cloth. Rinse thoroughly.
Even though your kettle comes with
l
a filter, you still need to clean the
inside (and the filter) regularly.
the filter
1 Open the lid.
2 Unclip the filter by pushing down on
the arrow graphic 1 then lift the filter
out away from the spout area 2.
3 either rinse under the tap or use a
soft brush.
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 To refit – line the filter up with the
spout and slide the filter back into
the slot 3, then push forward and
clip securely into place.
Note: the lid cannot be closed if the
filter is not fitted correctly.
4
06/06/2022 16:09 06/06/2022 16:09