Operation; Initial Setup; Language Selection - Renkforce RF-IR-MONOV2 Bedienungsanleitung

10. Operation

a) Initial setup
When you switch on the device for the first time or if you have first reset it to the factory settings, the
language selection and the following messages appear on the display once you switch it on. The start-up
process takes a few seconds.

Language selection

• Use the rotary knob (7) or the corresponding arrow buttons (16) on the remote control to select the desired language.
• Confirm your selection by pressing the rotary knob (7) or the OK button (26) on the remote control.
Configuring the Wi-Fi connection
• Use the rotary knob (7) or the corresponding arrow buttons (16) on the remote control to select "YES".
• Confirm your selection by pressing the rotary knob (8) or the OK button (26) on the remote control. In the next
screen, select "Add/Remove AP" and confirm your entry again as described above.
• In the next screen, select "Add AP (Scan)" and confirm your entry again as described above.
Logging in with WPS button (simple option)
• In the next screen, select "Add AP (WPS button)" and confirm your entry again as described above.
• Press the WPS button on your Wi-Fi router to establish the connection
Add/Remove AP
AP:[ ]
Add AP
(Scan)
Remove AP
45