B) Inserting Or Changing The Remote Control Batteries; Charging The Built-In Rechargeable Battery - Renkforce RF-IR-MONOV2 Bedienungsanleitung

b) Inserting or changing the remote control batteries

You must first insert the batteries into the remote control before you can start using it. Proceed as follows:
• Open the battery compartment cover on the back of the remote control.
• Insert two AAA batteries into the battery compartment. Pay attention to the correct polarity (plus/+ and minus/-).
There are corresponding markings in the battery compartment.
• Replace the battery compartment cover.
If the range of the remote control decreases or it no longer works, change the batteries as described above.
c) Charging the built-in rechargeable battery
The device is powered by a built-in rechargeable battery. Use the supplied power adapter to charge the battery.
The mains socket to which the power adapter is connected must be near the device and easily accessible
so that the power adapter can be quickly and easily disconnected from the mains socket in the event of a
fault.
Ensure that the voltage indicated on the power adapter corresponds to the mains voltage of your power
supply. Never try to operate the power adapter at a different voltage.
Be careful when handling the power adapters and mains connectors. Mains voltages can cause fatal
electric shocks.
Do not leave cables lying around; ask an electrician to lay them properly to prevent the risk of an accident.
The device can be used while the battery is charging, but it will take more time to charge the battery.
Fully charge the battery before using the device for the first time.
• Insert the USB-C plug of the power adapter into the USB-C input connection (9).
• Plug the power adapter into a wall socket.
• The charging indicator (12) lights up red during charging.
• When the battery is fully charged, the charging indicator (12) turns green.
When the device is switched on, the battery status icon is displayed in the top line:
44
Battery status: the more segments light up, the higher the battery status; if the icon flashes,
the battery must be charged
Battery is charging
Battery is charged and the power adapter is connected