Werbung
Verfügbare Sprachen
Verfügbare Sprachen
!
!
!
!
!
!
!
For further safety instructions refer to the enclosure!
Mounting the core drill tool on the
Mounting the mounting plate
Dimensions of the motor
unit
Downloaded from
www.Manualslib.com
Stop operating when water is seeping out of the overflow tap in the
gear collar and take the tool to an authorized service point.
After an interruption of operations, the engine should only be switched
on again if the drill bit can be turned freely.
When operating the tool always wear ear protection.
Do not touch rotating parts.
Persons under 16 years of age must not operate the tool and persons
over 16 and under 18 must only use under close supervision
The operator and persons in the vicinity must wear appropriate safety
goggles, protective helmet, ear protection, protective gloves and safety
shoes during operations.
Always work with concentration. Do proceed with consideration
and do not operate the tool when not fully concentrated.
diamond drilling stand P-54190
manuals search engine
Use the turnstile to open the
locking device of the mounting
plate. Take it out and connect
it to the core drill as described
below.
The drilling stand P-54190 comes with a mounting
plate, a 10 mm fitting key and 4 hexagon hollow
head plugs M8. The mounting plate is fixed on the
tool with the fitting key so that the coupling on the
mounting plate is on the same side as the gear
change of the engine. The 4 plugs are then
inserted and tightened.
18
Werbung
