Abus RWM450 Bedienungs-, Installations- Und Wartungsanleitung Seite 45

Repeat Connection Attempts
First, deactivate the unit completely:
1. Pull out red activation
button
2. Press and hold Test/ Stop
button 2 – 3 seconds
3. Pull out red activation button;
radio setup re-starts.
Extending the Existing Radio Group /
Re-entering Connection Mode
Once 10 minutes have passed during
setup of the radio group in which some
alarms are still in connection mode,
these devices must be put into connec-
tion mode again if still further devices
are to be added to the radio group:
Downloaded from www.Manualslib.com manuals search engine
1. Press black activation pin into marked
opening and hold until LED lights
yellow; continue to hold until LED
blinks yellow.
2. Pull activation pin back, then, for
all alarms added to the radio
group thus far:
LED
1 second
Signal:
Meaning:
After 5–15 seconds:
LED
Signal:
Meaning:
– 45 –
short yellow pulse
(lights only very briefly)
Connection mode is acti-
vated on all RISAs of this
radio group
green steady signal
Connection mode is acti-
vated on all RISAs of this
radio group
GB