Preparing For Installation - Sentiotec Pro-DMX Montage- Und Gebrauchsanleitung

Installation instructions, only for experts

4.1. Preparing for installation

Refer to Fig. 1.
ATTENTION!
Damage to the unit
● The lighting control unit 2 is splashproof (protection class IP X4).
● Work on the lighting control unit may only be carried out using a standard
screwdriver. Using a cordless screwdriver may irreparably damage the housing.
1. Cut the mounting hole the cabin wall with a jigsaw.
2. The minimum installation depth for a wall cut-out is 35 mm.
3. Remove any insulation from the mounting hole.
4. Lay the connecting cable in the wall of the sauna cabin to the mounting hole
and fasten it with cable ties.
Fig. 1: Installation in wall cut-out
Fig. 2: Connecting the device (rear)
48 mm
p. 4/8