Setup And Installation - Daikin AHT KINLEY X5 Betriebsanleitung

AHT Cooling Systems GmbH | en
WARNING
Dispose of packaging material and
film.
Suffocation hazard.
§ Keep packaging material and film away
from children.
§ Do not allow children to play with pack-
aging material or film.
CAUTION
Sharp edges of the appliance. Heavy
appliance parts.
Cutting injuries to the hands. Hands may be-
come trapped.
§ Great care should be afforded to fingers
and hands.
§ Wear protective gloves.
NOTICE
Material and property damage due to missing
parts in the appliance.
§ Check the packaging for loose parts.
§ Do not dispose of loose parts; clarify their use with
the maintenance service [see } Chapter 12.4].
Transport locks
Display shelves/mesh baskets are secured with trans-
port locks.
1
Fig. 15: Transport lock (1), transport lock level (2)
Remove transport lock
a) Push the lever of the transport lock downwards
and then pull the transport lock out to the front.
b) Dispose of the transport lock in an environmentally
friendly manner.
8

Setup and installation

Responsibility
– Qualified staff
This work must be carried out in accordance with the
installation instructions II-30.
These instructions are available from qualified staff.
Technical data for interfaces [see } Chapter 3.2].
Technical modifications to the appliance only in agree-
ment and after approval of the manufacturer.
376840_1_0920
2
Setup and installation | 8
WARNING
Damage to the refrigerant circuit.
Flammable refrigerant can escape and cause
an explosive gas/air mixture. Fire hazard.
§ Do not obstruct the ventilation openings in
the appliance housing. Use only original
accessory parts.
§ Only install the appliance in well-ventilated
rooms.
§ If the appliance is installed in cellars, you
must ensure that there is sufficient ventila-
tion.
§ Ducts and wall bushings must be sealed
under and behind the unit to protect
against fire.
§ Do not drill holes in the appliance and do
not carry out any other work on the appli-
ance.
§ Do not crush or bend pipes.
Appliance tipping hazard.
Persons may become trapped.
§ Remove the transport frames only when in
the stable and final installation position.
§ Anti-tipping device for wall mounting:
Attach the appliance properly to the wall
(see separate installation instructions -
II-030).
§ Anti-tipping device for island installation
(back to back):
Connect the appliances properly (see sep-
arate installation instructions - II-030).
§ Anti-tipping device for stand-alone installa-
tion:
Anchor the appliance stand securely to
the ground (see separate installation in-
structions - II-030).
When drilling, pay attention to the struc-
tural properties of the ground and the sub-
surface (floor heating, electrical cables,
etc.).
§ Do not climb onto or into the appliance.
§ Only qualified staff may transport the ap-
pliance following setup.
CAUTION
Material breakage.
Falling hazard. Impact hazard due to the pos-
sibility of falling goods. Cuts.
§ Do not climb onto or into the appliance.
Sharp edges of the appliance. Heavy
appliance parts.
Cutting injuries to the hands. Hands may be-
come trapped.
§ Great care should be afforded to fingers
and hands.
§ Wear protective gloves.
51 / 788