Atag EG3 UT Serie Installationsvorschrift Seite 12

mounting fitting case
1
Place the outer fitting case on the (as yet
not fully tightened) 3 threaded rods using
the 3 slotted holes (A). Secure the fitting
case using the 3 threaded rods (B).
2
Screw the 4th threaded rod (A) into the
ceiling (B) to a depth of 20 mm.
GB 8
3
Remove the nut (A). Screw on the fourth nut
(B). Tighten the remaining 3 nuts securely.
4
Slide the bottom fitting case C into the
fitted top fitting case B. Determine the
height required (see the build-in dimensions
chapter).
5
Secure the fitting case using the 8 screws G.
6
Recirculation version: Connect the flexible
pipe to the T-piece M. Screw screw P into
the opening.
GB 9