hanseatic HGS8555CW Gebrauchsanleitung Seite 52

Page EN-22 Start-up
If the mains plug is no longer acces-
■
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; this in-
cludes fuses, circuit breakers and con-
tactors.
When positioning the appliance, en-
■
sure the supply cord is not trapped
or damaged. Do not kink the supply
cord or lay it over sharp edges.
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
Connect the appliance only to a
■
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage!
If the refrigerator has been transported
vertically, lubricant from the compres-
sor may have got into the refrigeration
circuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily acces-
sible and properly installed socket (220-
240 V~ / 50 Hz).
You will find all important information
about operation from page EN-11.