Care And Maintenance; Checking And Cleaning Door Seals . En; Clean Exterior; Defrost And Clean Appliance - hanseatic HGS8555CW Gebrauchsanleitung

Care and maintenance

WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
Before cleaning, unplug the mains
■
plug from the socket or isolate/un-
screw the fuse.
When pulling out the mains plug, al-
■
ways take hold of the mains plug it-
self and never the mains cord.
CAUTION
Dangers for children and people with
limited physical, sensory or mental ca-
pacity!
Cleaning and user maintenance must
■
not be carried out by children unless
they are supervised.
NOTICE
Risk of damage!
The surfaces and appliance parts can be
damaged through improper handling.
Never use harsh, granular, soda, acid,
■
solvent-based or abrasive cleaners.
These attack the plastic surfaces.
All-purpose cleaners with a neutral
pH are recommended.
Door seals and plastic parts are sen-
■
sitive to oil and grease. Remove con-
taminants as quickly as possible.
Only use soft cloths.
■
Care and maintenance
Checking and cleaning door
seals
The door seals must be checked regularly so
that no air can enter the appliance.
1. To test them, clamp a thin piece of paper
in various places. The paper should be
difficult to pull through at all points.
2. If the seal is not uniform everywhere:
Warm the seal in the appropriate places
in front of you with a hair dryer and pull it
out with your fingers.
3. Only clean dirty seals with clean water.

Clean exterior

– Painted surfaces
Use only light pH-neutral soapy water.
– Stainless steel surfaces
Use special stainless steel cleaner from a
specialist shop. Never use polish.

Defrost and clean appliance

WARNING
Risk of explosion and injury!
Improper handling of the appliance can
lead to serious injuries and damage!
Never use defrosting sprays. They can
■
generate explosive gases.
The thermal insulation of your ap-
■
pliance is made of sensitive insulat-
ing material. Therefore, do not use
any electrical heating equipment, ice
scrapers, knives, defrosting sprays,
boiling water or any kind of aid with
an naked fl ame, for example candles,
to speed up the defrosting process.
The thermal insulation and the interi-
or are scratch and heat-sensitive and
can melt.
Page EN-15