hanseatic HGS17060EW Gebrauchsanleitung Seite 48

Troubleshooting
Troubleshooting
WARNING
Risk of electric shock and injury!
Improper repairs of a defective freezer put the person carrying out the repairs and
the user in danger.
• Only allow authorised specialist staff to repair the freezer. If in doubt, contact our
service department.
• Only carry out the actions which are described in this user manual.
Use this table to check if you can correct the fault yourself.
Problem
The compressor is
switched off.
The freezer cools
excessively.
The freezer does not
cool sufficiently.
The freezer makes
noise.
EN-22
Possible cause
The socket has no power.
The mains plug has not been inserted
properly.
The desired temperature has been
reached.
The temperature is set to a cooling
power that is too high.
The temperature is set to a cooling
power that is too low.
Door is not tightly closed or door seal
is not completely tight.
The freezer is near a heat source.
The foods inside are warm and have
not been cooled.
The ambient temperature is too low or
too high.
Cooling unit is running (humming).
Refrigerant is flowing through the pipes
(flow noise).
Motor is switching on or off (clicking).
Other, non-operational noises.
Solution
Check the socket by connecting anoth-
er appliance.
Ensure the mains plug is securely
plugged in.
Further cooling not required. When the
inside temperature rises, the compres-
sor automatically switches on.
Set the temperature controller 1
further towards "MIN".
Set the temperature controller 1
further towards "MAX".
See chapter „Cleaning the door seal"
on page EN-21.
Place an insulating plate between the
freezer and heat source, or change the
location.
Only place chilled food back in the
freezer.
Adjust the ambient temperature. (See
chapter „Intended use" on page EN-4.)
Operating noises are functional and
are not a sign of malfunction.
Check the firm position.
Remove objects from the freezer.
Remove any foreign bodies from the
rear and leave sufficient clearance to
the wall.
HGS17060EW, HGS17060ES