Technical Specification; Troubleshooting - Hallde RG-200 Bedienungsanleitung

• Do not use abrasive detergents or cleaning
products.
AVOID: Do not use cleaning sponges with
scouring pads (e.g. Scotch-Brite™) unless
absolutely necessary. This roughens the
surface and makes it less water repellent.
ADVICE ON CARE:
• Clean the machine immediately after use.
• Dry the machine immediately after cleaning
to avoid oxidation and discoloration of the
surface.
INFORMATION: If the machine is left damp for
longer periods stains will appear. These stains
are harmless but the original surface will lose
its lustre. Vegetables and fruit contain acids.
Depending on which products are processed
this will have an effect on the metal after
varying periods of time. It is therefore important
to clean the machine immediately after proces-
sing salty and acidic products.
TROUBLE SHOOTING
To eliminate the risk of damage to the motor,
the RG-200 is fitted with thermal motor protec-
tion that automatically switches off the machine
if the temperature of the motor should become
too high. The thermal motor protection has
automatic reset, which means that the machine
can be started again when the motor has
cooled down, which usually takes between 10
and 30 minutes.
FAULT: The machine cannot be started,
or stops while it is running and cannot be
restarted.
REMEDY: Check that the plug is securely fitted
into the power supply socket. Check that the
feed cylinder is locked in the correct position.
Move down the pusher plate into the feed
cylinder. Check that the fuses in the fuse box for
the premises have not blown and that they have
the correct rating. Wait for a few minutes and
try to restart the machine. If the machine still
fails to run, call in a qualified service mechanic.
FAULT: Low capacity or poor cutting results.
REMEDY: Make sure that you are using the
correct cutting tool or combination of cutting
tools. Fit the decoring device. Check that the
knives and grater/shredder plates are in good
condition and are sharp. Press the food down
loosely with less force.
FAULT: The cutting tool cannot be removed.
REMEDY: Always use the wrench. Use a thick
leather glove or other glove that the knives of
the cutting tool cannot cut through, and turn
the cutting tool clockwise to release it.
FAULT: The decoring device cannot be
removed.
REMEDY: Use the wrench to unscrew the
decoring device clockwise.
4

TECHNICAL SPECIFICATION

HALLDE RG - 200
MACHINE: Motor: 0.25 kW, 230 V, single-
phase, 50 Hz, with thermal motor protection.
Transmission: gears. Safety system: Two
safety switches. Degree of protection: IP44.
Power supply socket: Earthed, single-phase,
10 A. Fuse in fuse box for the premises: 10 A,
delayed. Sound level LpA (EN31201): 73 dBA.
TOOLS: Diameter: 185 mm. Speed: 350 rpm.
NET WEIGHTS: Machine: 18 kg. Cutting tools:
About 0.5 kg on average.
NORMS/STANDARDS: NSF STANDARD 8,
see declaration of conformity.
HALLDE • User Instructions