Scanning The Switching System; Adding Target Devices To The Scan List - Fujitsu SIEMENS COMPUTERS KVM s3 Serie Bedienungsanleitung

3.12
In scan mode, the KVM s3-1621 and KVM s3-1641 appliances automatically scan from
port to port (target device to target device). Use scan mode to monitor the activity of up
to 16 target devices, and to specify which target devices to scan and the number of
seconds that each target device will be visible. The scanning order is determined by
placement of the target device in the list, which is always shown in scanning order. You
can choose to list the target devices by name, EID number, or port number by clicking
the corresponding button.
3.12.1
Click Setup - Scan. The Scan window opens.
Figure 25: Scan window
The window contains a listing of all target devices that are attached to the KVM s3-
1621 or KVM s3-1641 appliance. To select target devices to be scanned, complete
one of the following steps:
•
•
•
In the Time field, type the number of seconds (from 3 to 255) of time before the
scan moves to the next target device in the sequence.
Click OK.
590-591-609B
Downloaded from www.Manualslib.com

Scanning the switching system

Adding target devices to the scan list

Select the check box next to the target devices that you want to scan.
-or-
Double-click on a target device name or port.
-or-
Press Alt and the EID number of the target device that you want to scan. You
can select up to 16 target devices from the list.
manuals search engine
Scanning the switching system
39