Troubleshooting - Nilfisk CTS22 Betriebsanleitung

CTS22 / CTS22 L-M-H / CTS40 L-M-H / CTT40 L-M-H / BDC40 H
Translation of original instructions
Problem
The vacuum cleaner suddenly stops
Dust leaks from the vacuum cleaner
The vacuum cleaner blows instead
of vacuuming
Electrostatic current on the vacuum
cleaner
GB
C313

Troubleshooting

Cause
Clogged primary filter
Clogged vacuum hose
Circuit breaker activation
The filter is torn
Inadequate filter
Incorrect connection to the electrical
mains
Non existent or inefficient grounding
14
Remedy
Shake the filter. Replace it if necessary
Check the vacuum hose and clean it.
Check the setting.
Check the motor electrical input. Contact
an authorized after-sales service centre if
necessary.
Replace it with another of identical type.
Replace it with another of a suitable
category and check.
Ask for assistance from qualified
personnel to perform the correct phase
connection.
See page 8, Starting up chapter
Check all ground connections. Especially
check the inlet.
01/2015