What To Do If - IKEA MÖJLIG 502.371.37 Bedienungsanleitung

ENGLISH
Removing the residues and stubborn
residues:
1. Food containing sugar, plastics, tin foil
residues should be removed at once,
best tool for cleaning glass surface is a
scraper (not included with the appli-
ance). Place a scraper on the glass ce-
ramic surface at an angle and remove
residues by sliding the blade over the

What to do if...

Problem
The cooking zones will
not switch on or are not
functioning.
Acoustic signal sounds,
appliance switches off.
The residual heat indi-
cator is not displaying
anything.
symbol plus a num-
ber appears on the
heat setting display.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or the After Sales Service.
Downloaded from www.Manualslib.com
Possible cause
More than 10 seconds passed
since you switched on the hob.
The child safety device or the
Lock is on
Several sensor fields were
touched at the same time.
One or more sensor fields have
been covered for longer than
10 seconds.
The cooking zone was only on
for a short time and is there-
fore not hot.
Electronics fault.
manuals search engine
surface. Wipe the appliance with a
damp cloth and a little washing up liq-
uid. Finally, rub the appliance dry using
a clean cloth.
2. Limescale rings, water rings, fat
splashes, shiny metallic discolorations
should be removed after the appliance
has cooled down using cleaner for
glass ceramic or stainless steel.
Switch the appliance on again.
Deactivate the child safety de-
vice (See the sections "Child
.
safety device " or "Lock").
Only touch one sensor field.
Uncover sensor field.
If the cooking zone is supposed
to be hot, call the After Sales
Service.
Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house's electric system) If
after switching on again,
displayed again, call the cus-
tomer service department.
If you operated the appliance wrongly,
or the installation was not carried out
by a registered engineer, the visit from the
customer service technician or dealer may
not take place free of charge, even during
the warranty period.
9
Remedy
is