hanseatic HGVI6082D127711DS Gebrauchsanleitung Seite 72

Page EN-32 Installation, fitting and connection
8. To enable the dishwasher to be posi-
tioned levelly, both front and back appli-
ance feet can be adjusted by up to 5 cm.
– Both front feet are equipped with slots.
Insert a screwdriver into one of the slots
and use it to turn the appliance feet to
the desired height.
– You can use the middle adjustment
screw (22) to adjust the height of the rear
appliance foot. Use a Phillips-tip screw-
driver for this.
9. Check the alignment with a spirit level.
10. Make sure the top edge of the dish-
washer is up to the bottom edge of the
worktop to prevent it from tipping forward
when you open the dishwasher door.
(22)
11. Screw the dishwasher to the kitchen unit.
– If you have granite worktops, remove
the internal side cover caps (f) and
screw the dishwasher to the adjacent
kitchen cupboards.
Re-cover the screws (g) with the cover
caps.
– For all other worktops, screw the
mounting bracket (e) using the screws
(h) to the work surface until it is fixed.
(e)
(h)
(f) (g)