Temperature Setting - STORZ & BICKEL Mighty Gebrauchsanweisung

7. C O M M I S S I O N I N G A N D O P E R AT I O N
vibration. The vibration does not take
place if there is a fault.
The display signals that heating is in
progress by showing the set and actual
temperatures. Set the desired temper-
ature using the temperature buttons to
the left and right of the set temperature
display. Heating up the heat exchanger
can take up to two minutes, depend-
ing on the set temperature and battery
charge level. Once the set temperature

7.3. Temperature Setting

Set temperature display
(displayed blinking:
booster temperature)
Minus temperature button
The temperature can be set between
40°C and 210°C (104°F and 410°F)
(see Chapter 4. "Overview of Plants",
page 45).
When you press the plus button, the
set value is increased, and when you
press the minus button, the set value is
decreased. When you briefly tap on the
plus or minus button, the set values are
increased or decreased respectively in
1-degree increments. If you keep the
is reached, this is signaled by a short
double vibration.
If the basic temperature can no longer
provide adequate evaporation, the
booster temperature can be activated
by means of a double-click on the
orange-colored ON/OFF switch. Once
the booster temperature is reached,
this is signaled by a short double vibra-
tion and a blinking Set Temperature
display.
plus or minus button pressed, the set
values start running continuously in
the corresponding direction.
The booster temperature can be ad-
justed in the same way. However, it
cannot be set lower than the previous
set temperature.
The current actual temperature can be
read from the upper line of the display.
51
Actual temperature display
Plus temperature button
Battery charging display