Commissioning And Operation; Charging The Battery - STORZ & BICKEL Mighty Gebrauchsanweisung

7. C O M M I S S I O N I N G A N D O P E R AT I O N
Do not leave the device unat-
tended
Place the MIGHT Y Vaporizer
only on a hard, heat-resistant, flat, sta-
ble surface, never on soft surfaces or
flammable material. Check whether
the power adapter supply voltage cor-
responds to the voltage rating listed on
the power adapter. The power adapter
cord and power adapter must be in
perfect condition. Connect the power
adapter only to a properly installed
socket.
The manufacturer will not bear any
responsibility whatsoever if this acci-
dent prevention measure is not taken.
To completely disconnect from the
mains power supply, please unplug the
power adapter from the mains socket.

7.1. Charging the Battery

Explanation of the battery charging
display:
The battery charging display shows a
battery symbol with six fields indicat-
ing the charging status. If the battery is
almost discharged, the battery frame
starts to flash; if fully charged, the
frame and all six fields are visible.
The number of status fields visible
depends on the extent of the battery
charge.
Battery charging display
during operation.
Check the housings of the Va-
porizer and the power adapter
for signs of damage each time
before using or charing. The Vaporizer
may not be charged and neither Vapor-
izer nor power adapter used if these
are damaged.
The battery charge of the new prod-
uct has a level of up to 80%. Fully
charge before using for the first time.
The charging time for the battery de-
pends on how old it is and how high
the charge is on starting; it takes about
two hours if the battery is completely
discharged.
Connect the power adapter to the
charging socket of the Vaporizer and
then plug into a suitable power socket.
Note: When the power adapter is
plugged into the mains, the display
lights up for a moment and the Vapor-
izer vibrates for a short time. This is a
functional check and indicates that the
charging operation has started.
The battery charging display lights up
and starts to flash, i.e. the battery is
being charged. As soon as the battery
is fully charged, the battery charging
display stops flashing and indicates
the charge level (full = all six fields).
Once the charging operation is com-
plete, first disconnect the power
adapter from the mains socket and
then unplug from the Vaporizer.
49