Kemppi FLEXLITE TX Betriebsanleitung Seite 8

3. Prior to installing the tungsten electrode, grind the electrode tip to the appropriate dimensions for your welding
application. For more information, refer to the section "Electrode tip" on page 19.
4. Push the electrode into the torch and through the collet and gas nozzle.
5. Install the electrode back cap. Tighten the back cap to lock the electrode in place.
Do not use excessive force. Overtightening may damage the torch components.
By loosening the electrode back cap, the electrode can be installed also by pushing it into the torch from the other side.
© Kemppi
9
Flexlite TX
Operating manual - EN
1920910 / 2039