Kemppi FLEXLITE TX Betriebsanleitung Seite 10

3. Connect the torch remote control circuit board to the connector and place it in its slot in the handle. (Rocker
switch model shown on the left and roller switch model on the right:)
4. Install the new switch cover by placing the front end of the cover in first and then pushing the rear end of the
cover down. (Rocker switch model shown on the left and roller switch model on the right:)
5. Secure the switch cover in place with the two screws in the rear section of the cover.
© Kemppi
11
Flexlite TX
Operating manual - EN
1920910 / 2039