Installation - Kemppi FLEXLITE TX Betriebsanleitung

3. INSTALLATION

Ensure that the welding equipment is not connected to the mains or that the welding torch is not connected to the
welding machine at this stage.
Protect the equipment from rain and direct sunshine.
"Assembling torch" on the next page
"Installing torch remote" on page 10
"Installing start switch extension" on page 12
"Connecting torch" on page 14
Before installation and use
Ensure compliance with your local and national safety requirements regarding the installation and use of high
voltage units.
Check the contents of the packages and make sure the parts are not damaged.
Do not connect welding equipment to the mains before the installation is complete.
© Kemppi
7
Flexlite TX
Operating manual - EN
1920910 / 2039