Kemppi FLEXLITE TX Betriebsanleitung Seite 23

• Protective hose or another insulation of torch is broken and ignition spark is "escaping".
• Torch is wet.
• Too big or blunt electrode is used at low currents.
Gas shielding is bad (weld pool "boils", electrode gets oxidized)
• There are impurities in shielding gas (moisture, air).
• There are impurities in base material (rust, base coat, grease).
• Impurities stuck on gas nozzle or on collet body.
• Net of gas lens is damaged.
• There is too much draft at welding place.
© Kemppi
24
Flexlite TX
Operating manual - EN
1920910 / 2039