Climadiff CVV Serie Gebrauchsanweisung Seite 39

ligths when the
compressor is
working, during
cold cycles
The temperature range can be set as low as 5°C or as high as 18°C to suit your specific storage
requirements. The acquiescence temperature setting is 12°C.
How to set the temperature:
The temperature preset in factory for this model is 12 ° C. SET and the arrows are used to change settings.
To change the temperature:
 Press SET, "SP" will be shown on the display and press SET again and the current value will be shown
 Press simultaneously SET and the upper arrow
 Press UP or DOWN arrows to change the set point value between 5 and 18°C
 Press SET to accept the new value
 Press SET and down arrow at the same time to exit the programming mode or wait 1 minute to
automatically exit
The thermostat in your wine cellar only controls the production of cold air. If your wine cellar is equipped with
the winter system and is intended for use in an unheated area, the heating circuit is factory preset and you
do not need to adjust it.
Don't worry if your thermometer doesn't indicate exactly 12°C! Inertia of liquid with respect to air is a factor of
1 to 10 and your cellar will make the necessary corrections automatically.
5. EQUIPMENT
The ventilation system: charcoal filter
Pure air continually changed and filtered.
Your Climadiff wine cellar is equipped with a continuous fresh air system, filtered by a charcoal filter. This is
a 5 cm diameter black plastic washer in the top left of the cellar at the back. It should be replaced annually
and can be bought from the accessories section of our web site at www.climadiff.com.
Push the charcoal filter from the outside of your wine cellar in order to remove it from inside the appliance.
The hole visible in the rear lower section is normal and provides negative pressure, to ensure internal air
circulation.
°C shows the
temperature
value unit
39