General Instructions - HELIX DSP Bedienungsanleitung

Congratulations!
Dear Customer,
Congratulations on your purchase of this high-qua-
lity HELIX product.
With the HELIX DSP, Audiotec Fischer is setting
new standards for digital signal processors.

General instructions

General installation instructions for HELIX
components
read this manual carefully and follow all installati-
on instructions. This product has been checked for
proper function prior to shipping and is guaranteed
against manufacturing defects.
Before starting your installation, disconnect
the battery's negative terminal to prevent
a proper performance and to ensure full warranty
duct installed by an authorized HELIX dealer.
Install your HELIX DSP in a dry location with suf-
equipment. The processor should be secured to
a solid mounting surface using proper mounting
area around and behind the proposed installati-
on location to insure that there are no electrical
cables or components, hydraulic brake lines or any
part of the fuel tank located behind the mounting
surface. Failure to do so may result in unpredictable
damage to these components and possible costly
We wish you many hours of enjoyment with your
new HELIX DSP.
AUDIOTEC FISCHER
General instruction for connecting the HELIX
DSP processor
stem. Any other system may cause damage to the
Use only the enclosed connectors or an Easy
Plug cable for connection of the HELIX DSP. The
use of other cables can result in damage of the
For
loudspeakers!
-
Prior to installation, plan the wire routing to
All cabling should be protected against possible
cables close to potential noise sources such as
electric motors, high power accessories and other
-
-
11