HELIX DSP Bedienungsanleitung Seite 16

5. Connecting the remote input
The remote input has to be connected to the radio
are used as signal inputs. We do not recommend
to be connected as long as the used car radio has
BTL output stages.
Installation with „Easy Plug cable"
To simplify installing to an OEM or aftermarket ra-
dio the HELIX DSP can also be connected using
the optional Easy Plug Cable. The processor will be
supplied with both power and radio loudspeaker si-
to be cut using this connection method.
Connection to an OEM radio is detailed below:
tools disconnect the OEM harness from the radio.
HELIX Easy Plug Cable.
scher adaptor list to check whether you need an
additional adaptor for connection. Check online at
2. Connect the cable plugs to the car radio.
and the power supply plug (4-pole connector) to the
appropriate HELIX DSP inputs.
4. Please note when connecting the power supply
The HELIX DSP should not be plugged into the po-
interference. Before connecting the HELIX Easy
blue and red wires coming from the ISO connectors
16
6. Connecting the remote output
This output is used to supply remote signals to the
id on/off switching noise.
turned off.
wire with jack to the corresponding blue or red wire
Attention: The red cable with plug and the red ca-
If you're uncertain of assignment ask your dea-
ler.
-
- Note - Cars equipped with MOST bus:
In cars equipped with MOST bus structure it is
original radio connector and insert it into the ISO
adaptor, which has a dedicated recess for this.
-
-