General Instructions - HELIX DSP.3 Handbuch

Congratulations!
Dear Customer,
and high-qual ity HELIX product.
HELIX DSP.3 sets new standards in the range of
digital signal processors.

General instructions

General installation instructions for HELIX
components
read this manual carefully and follow all installation
instructions. This product has been checked for
proper function prior to shipping and is guaranteed
against manufacturing defects.
Before starting your installation, disconnect
the battery's negative terminal to prevent
a proper performance and to ensure full warranty
uct installed by an authorized HELIX dealer.
Install your HELIX DSP.3 in a dry location with suf-
ment. The signal processor should be secured to
a solid mounting surface using proper mounting
area around and behind the proposed installa-
tion location to insure that there are no electrical
cables or components, hydraulic brake lines or any
part of the fuel tank located behind the mounting
surface. Failure to do so may result in unpredictable
damage to these components and possible costly
We wish you many hours of enjoyment with your
new HELIX DSP.3.
Yours,
AUDIOTEC FISCHER
General instruction for connecting the HELIX
DSP.3 signal processor
The HELIX DSP.3 signal processor may only be in-
terminal connected to the chassis ground. Any other
system could cause damage to the signal processor
For
total current draw of the car audio system.
-
Use only the provided connectors for connec-
tion of the HELIX DSP.3. The use of other con-
nectors or cables can result in damage of the
- signal processor, the head unit / radio or the
Prior to installation, plan the wire routing to
All cabling should be protected against possible
cables close to potential noise sources such as
electric motors, high power accessories and other
15