Treadmill Start Description - SPORTSTECH F48 Benutzerhandbuch

4. Click „Cancel" on the above dialogue box to
cancel the maintenance; click „Ok" to
complete the maintenace.
5. If you run for 50 km after last maintenance,
Maintenance Information will pop up when you
stop or start, see below:
6. Click „Cancel' in the above Maintenance Infor-
mation box; the system will take it that the treadmill

10. TREADMILL START DESCRIPTION

Start method:
1. Operate Start on the screen (or the Start on the keyboard), countdown of 3s will show in themiddle
of the screen with voice hint of "Start" countdown of 3s, then treadmill motor starts.
2. Operate Speed+ on the screen to increase the speed of treadmill of up to 24.8KM.
3. Operate Speed- on the screen to decrease the speed to a minimum of 0.8KM.
4. Operate Speed+ and Speed- on the keyboard, with the same functions of that of the above.
5. Operate Raise and Fall on the screen to increase the raise slope to a maximum of section 20.
6. Operate Raise and Fall on the screen to lower raise slope of the treadmill to a minimum of section 0.
7. Operate Start on the screen, with the functions same to that said above in 5 and 6.
8. When the treadmill is running, operate Stop on the screen (or Stop on the keyboard) to stop the
treadmill motor.
Safety lock:
In any state, pull the Safety lock for emergency stop of the treadmill, you will see "Safety lock falls off,
please check" on the screen, with Safety lock electronic table reset to enter into the home screen.
hasn't been maintained; if you click „Maintained",
the treadmill will be regarded as maintained and
the following box will show:
7. In the above dialogue box, dick „Cancel'' to
cancel the maintenance; Click „Ok" to complete
the maintenance. This window won't automatically
pop out for reminding users until the next main-
tenance period.
66