NORAUTO RECOVERY Bedienungsanleitung Seite 141

PART 2
Under Load (accessories ON): Next, load the alternator by turning on as many accessories as
possible (Front light, wiper blade, A/C, fan, etc.). This test under load allows you to check if the
alternator is able to supply enough current together to the battery and electrical accessories of your
car.
Refer to the operation as described above.
Notes: The unit may detect that the alternator is out of typical voltage range because someone has
added a number of accessory loads on the charging system, thereby increasing current demand from
the alternator.
MAKE SURE THAT THE ALTERNATOR IS RATED TO SUPPORT THE APPLICATION.
This check may not be accurate for every make, manufacturer and model of car.
Check only 12 volt / 24volt systems.
USE THE RECONDITION FUNCTION
Periodic reconditioning is recommended to maintain a battery's optimum performance. Battery
recondition sends a series of electrical pulses to break up the crystalline form of lead sulfate
and turn these chemicals into useful battery electrolytes.
1. Set up the battery charger and connect to the battery
following the step 1,2,3 in the connecting and charging
instruction.
2. Press the "RECOND" , the unit will automatically start
the battery reconditioning process.
IMPORTANT: If 5 cycles of reconditioning do not improve battery performance, discontinue
and recycle the battery.
1
To END the recondition process
The process stops automatically after 24 hours.
More than 24 hours may be needed to restore performance
on some batteries. If so, repeat the process.
To end the process sooner, press the RECOND button again to turn it
off and return to the Standby mode.
(A)
To indicate the unit is in the RECONDITION process
the LCD screen will show the above (A) or (B).
The 12V Icon or the 24V Icon and the empty
battery icon will display, and flashes the battery
recondition Icon
3
OR
141
2
(B)
OR
OR
.